Manufacturer article number: Mi60P

Manufacturer number: 50110172

Original spare part from HORIBA – guaranteed to fit the U-50 series perfectlyThe Horiba Reference Electrode Tip 7210 is a high-quality replacement part designed specifically for Horiba's U50 series of multiparameter measuring devices. It ensures a precise and stable reference voltage, which is essential for reliable measurement results in demanding environmental and water analyses. The electrode tip is easy to replace and helps to extend the service life of the entire system. Thanks to its robust design, it is ideal for use in harsh field conditions. With the 7210 reference electrode tip, your U50 measuring device will always be ready for use and perform at its best. Manufacturer article number: 3200043582

To ensure measurements remain reliable and accurate, it is important to regularly check the sensor and replace it with a spare sensor if necessary. The replacement sensor is specifically designed for the HORIBA LAQUAtwin Ca-11C for animal blood. This sensor is engineered to optimize user-friendliness and accuracy. With HORIBA replacement sensors, users can be confident that their devices consistently deliver optimal performance and precise results. Advantages of HORIBA Replacement Sensors: Easy Replacement: Sensors can be quickly replaced, allowing measurements to continue without delay. High Accuracy: Replacement sensors ensure that results are precise and reliable. Comprehensive Measurement Range: Various sensor types are available to measure a wide range of parameters. Durability: Sensors are designed for long service life, even under challenging conditions. Sensor Replacement Instructions: To ensure the longevity and accuracy of your HORIBA LAQUAtwin Pocket Tester, please follow these instructions when replacing a sensor: Removing the Sensor: Turn off the tester. Carefully detach the sensor from the device and lift the sensor tip. Completely separate the sensor from the tester so that the two components are no longer connected. Installing the Sensor: Ensure the tester is turned off. Check that the waterproof gasket is clean and intact. Attach the sensor to the tester by inserting hook “A” on the back of the device into hole “a” on the sensor tip. Make sure the waterproof gasket is not twisted. Important: After replacing the sensor, it is essential to follow the steps in the user manual of the respective tester to make the device ready for accurate measurements. These manuals are available with the products. Calibration and, if necessary, conditioning are usually required. How can I tell if my sensor shows signs of wear? Check the sensor condition as follows: Perform a 2-point calibration to assess the sensor’s condition. If an error occurs during calibration, this indicates that the sensor has deteriorated. In this case, replacing the sensor is recommended. Regular checks and timely replacement of sensors are essential to maintain the high standards and reliability of water quality measurements performed with HORIBA LAQUAtwin Pocket Testers. S051 Calcium replacement sensor for Ca-11C Manufacturer article number: 3200772945

Manufacturer number: 50010252

Manufacturer number: 50002072Gel filling with porous separator, maintenance-free, fixed cable 3m, pH 0 to 14, temperature 0 to 60°C

Manufacturer number: 32200153Gel filling with porous separator, maintenance-free, fixed cable 3m, pH 0 to 14, temperature 0 to 60°C

Manufacturer article number: 50014413

Manufacturer number: 50004002

Manufacturer number: 50002082

Manufacturer article number: 50014443

Manufacturer number: 32105302

Manufacturer number: 51004132

Manufacturer number: 32105102

Manufacturer article number: 50014433

Manufacturer article number: 50014483

Manufacturer article number: 50014403

Manufacturer number: 50002002

Manufacturer number: 50010242

Manufacturer article number: 50014463

Manufacturer number: 33550743

Manufacturer article number: 50014423

Set of 5 bottles for DO7/3MT, LDO70/2MT and LDO70/10MT Manufacturer number: 50010272

Manufacturer number: 50010292