S051 Calcium exchange sensor for Ca-11C

To ensure measurements remain reliable and accurate, it is important to regularly check the sensor and replace it with a spare sensor if necessary.

The replacement sensor is specifically designed for the HORIBA LAQUAtwin Ca-11C for animal blood. This sensor is engineered to optimize user-friendliness and accuracy. With HORIBA replacement sensors, users can be confident that their devices consistently deliver optimal performance and precise results.

Advantages of HORIBA Replacement Sensors:

• Easy Replacement: Sensors can be quickly replaced, allowing measurements to continue without delay.

• High Accuracy: Replacement sensors ensure that results are precise and reliable.

• Comprehensive Measurement Range: Various sensor types are available to measure a wide range of parameters.

• Durability: Sensors are designed for long service life, even under challenging conditions.

Sensor Replacement Instructions:
To ensure the longevity and accuracy of your HORIBA LAQUAtwin Pocket Tester, please follow these instructions when replacing a sensor:

Removing the Sensor:

1. Turn off the tester.

2. Carefully detach the sensor from the device and lift the sensor tip.

3. Completely separate the sensor from the tester so that the two components are no longer connected.

Installing the Sensor:

1. Ensure the tester is turned off.

2. Check that the waterproof gasket is clean and intact.

3. Attach the sensor to the tester by inserting hook “A” on the back of the device into hole “a” on the sensor tip.

4. Make sure the waterproof gasket is not twisted.

Important:
After replacing the sensor, it is essential to follow the steps in the user manual of the respective tester to make the device ready for accurate measurements. These manuals are available with the products. Calibration and, if necessary, conditioning are usually required.

How can I tell if my sensor shows signs of wear?
Check the sensor condition as follows:
Perform a 2-point calibration to assess the sensor’s condition. If an error occurs during calibration, this indicates that the sensor has deteriorated. In this case, replacing the sensor is recommended.

Regular checks and timely replacement of sensors are essential to maintain the high standards and reliability of water quality measurements performed with HORIBA LAQUAtwin Pocket Testers.

S051 Calcium replacement sensor for Ca-11C

Manufacturer article number: 3200772945