Horiba LAQUAtwin S021 Salt Replacement Sensor for Salt-22 tester

The HORIBA LAQUAtwin Pocket Tester series provides a comprehensive solution for fast and precise measurement of water quality parameters directly in the field. To ensure these measurements remain reliable and accurate, regular monitoring of the sensors and, if necessary, replacement with spare sensors is crucial.

These replacement sensors are tailor-made for the HORIBA LAQUAtwin series and cover a wide range of types for various measurements: pH, conductivity, salinity, redox (ORP), as well as ion-selective sensors for sodium, potassium, nitrate, calcium, and fluoride. Each sensor is designed to maximize user-friendliness and accuracy, which HORIBA is renowned for in water quality testing worldwide. HORIBA replacement sensors guarantee users that their devices consistently deliver optimal performance and precise measurements.

Advantages of HORIBA Replacement Sensors:

• Easy Replacement: Sensors can be exchanged quickly, allowing uninterrupted measurement.

• High Accuracy: Replacement sensors ensure precise and reliable results.

• Wide Measurement Range: Various sensor types are available to capture a broad spectrum of water quality parameters.

• Durability: Sensors are designed for long service life, even under challenging conditions.

Sensor Replacement Instructions:
Follow these steps to replace the sensor and maintain the longevity and accuracy of your HORIBA LAQUAtwin Pocket Tester:

Removing the Sensor:

1. Turn off the tester.

2. Lift the sensor tip slightly and pull the sensor away from the device.

3. Completely detach the sensor from the tester.

Installing the Sensor:

1. Make sure the tester is turned off.

2. Ensure the waterproof gasket is intact and clean.

3. Attach the sensor to the tester so that hook “A” on the back of the device fits into hole “a” on the sensor tip.

4. Make sure the waterproof gasket is not twisted.

Important:
After replacing the sensor, follow the instructions in the user manual of the respective tester to make the device ready for accurate measurements. This typically includes calibration and, if necessary, conditioning.

How can I tell if my sensor is worn out?
Check the sensor condition as follows:
Perform a 2-point calibration. If an error occurs during calibration, this indicates that the sensor has deteriorated. In this case, the sensor should be replaced.

Regular checks and timely replacement of sensors ensure the high quality and reliability of your water quality measurements with HORIBA LAQUAtwin Pocket Testers.