Horiba LAQUAtwin S071 Salt Replacement Sensor for Salt-11 tester

The HORIBA LAQUAtwin Pocket Testers provide a comprehensive solution for immediate and precise measurement of water quality parameters directly in the field. To ensure that these measurements remain reliable and accurate, it is important to regularly check the sensors and replace them with spare sensors if necessary.

The replacement sensors developed for the HORIBA LAQUAtwin series cover various types for different measurements: pH, conductivity, salinity, redox (ORP), as well as ion-selective sensors for sodium, potassium, nitrate, calcium, and fluoride. All of these sensors are designed to maximize user-friendliness and precision, qualities for which HORIBA is globally recognized in water quality testing. HORIBA replacement sensors ensure that users’ devices consistently deliver optimal performance and accurate measurements.

Advantages of HORIBA Replacement Sensors:

• Easy Replacement: Sensors can be quickly exchanged, allowing measurements to continue without delay.

• High Precision: Replacement sensors ensure that results are exact and reliable.

• Wide Measurement Range: Various sensor types are available to capture a broad spectrum of water quality parameters.

• Durability: Sensors are designed for long service life, even under challenging conditions.

Sensor Replacement Instructions:
To ensure the longevity and accuracy of your HORIBA LAQUAtwin Pocket Tester, please follow these instructions when replacing a sensor:

Removing the Sensor:

1. Turn off the tester.

2. Carefully detach the sensor from the device and lift the sensor tip.

3. Completely separate the sensor from the tester so that the two components are no longer connected.

Installing the Sensor:

1. Ensure the tester is turned off.

2. Check that the waterproof gasket is clean and undamaged.

3. Attach the sensor to the tester by inserting hook “A” on the back of the device into hole “a” on the sensor tip.

4. Make sure the waterproof gasket is not twisted.

Important:
After replacing the sensor, it is essential to follow the steps in the user manual of the respective tester to make the device ready for accurate measurements. (These manuals are available with the products. Calibration and, if necessary, conditioning are usually required.)

How can I check if my sensor shows signs of wear?
Check the sensor condition as follows:
Perform a 2-point calibration. If an error occurs during calibration, this indicates that the sensor has deteriorated. In this case, replacing the sensor is recommended.

Regular checks and timely replacement of sensors are essential to ensure the high standards and reliability of water quality measurements performed with HORIBA LAQUAtwin Pocket Testers.